I am having difficulty with analog input on the DSerial Edge.
The project I am currently working on requires two analog input values; however, I seem to be unable to set up the DSerial properly to be able to read two analog input values.
I would like to use P2.3 and P2.5
If I initialize just one of those pins in my application, then that one pin will work.
However, if I try to initialize both pins as analog input, only P2.3 works (regardless of if I initialize P2.3 before P2.5 or vice versa).
I am assuming it's possible to have two analog inputs on the DSerial Edge.
***ADDITION: After looking over the data sheet for the MCU on the DSerial Edge again, I get the impression that there can be only one analog input, because there is only one ADC. Can someone corroborate this assumption?
Thanks for your time.
***ADDITION 2: Problem solved. I just alternated setting one of the pins to ANALOG_INPUT and the other pin to INPUT, so that they could take turns using the ADC. I also had to use swiDelay() to give the switching enough time to process.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests